If you want to fix lumpy gel nails, you will need a lot of patience because probably you will need to apply them all over again,or you can try fixing that nail with coats of gel.
After spending a good hour or two doing your gel manicure at home only to find out that the polish on one or more fingers looks wrinkled, bubbled or lumpy, the right way to fix it is to remove those bad gels; with acetone and apply them again!
Soak an old cotton ball in this remover before laying down foil wrapped around their nails so they don’t move while waiting 10-15 minutes for all chemicals to soak through into each individual strand between layers.
Note: This post may contain affiliate links, which means if you buy from my link I might make a small commission. This does not affect the price you pay. See the full affiliate disclosure here.
Another hack you can try is to repair the nail by following these steps below:
1. Apply a thin layer of clear nail polish to the top and bottom of the nails
2. Place another coat of gel on top, but this time do not apply it all over the nail
3. After waiting for about 30 seconds, use an orange stick or other similar object to push down on each side of the nail to smooth out any lumps that may have formed
4. Finish with a final coat of gel and let dry completely before applying any colour coats
How Do you Make Gel Nails Smooth?
If you want your gel nails to be smooth, you need to start with a base coat.
Apply the gel nail polish in long strokes, build up from one side of your nail to the other, and let each layer dry before applying another layer.
Once you have applied three layers, apply a top coat and let it dry for 10 minutes before adding any accessories like rhinestones or glitter.
Finally, add an additional topcoat and seal your nails with UV light for added protection against chipping and smudging.
Clean your nails. Clean, dry nails are required to apply gel polish to stick correctly and adhere well (Aquaphor or lotion around cuticles helps).
Shaking the bottle before each use is also recommended; if you aren’t sure what direction, getting an even coat on all four surfaces of whatever size/shape area needs more momentum.
It’s best not to go too fast while painting since this will cause bubbles near edges where there was no free edge product built up beforehand – take short strokes going only about 1 inch per second slower than normal hand movements when possible, so fewer brush widths needed!
Why Does My Gel Nail Polish Look Bumpy?
Why does my gel nail polish look bumpy? The answer is actually pretty simple.
It’s called “gel bumps”, which happens when the polish doesn’t properly cure under UV light.
A common misconception is that this issue can be solved by using a thinner top coat, but in reality, it only makes the problem worse.
Luckily there are a few easy fixes for this frustrating problem!
You can fix this problem by making sure you file down any bumps before applying a new coat of gel polish.
Apply clear polish over the nails and get rid of all your old polishes and buy new ones that are smoother (try brands like Sally Hansen)
Use a manicure set with brushes, files, and clippers to fix your nails before you paint them.
Paint your nails with topcoats or use an acrylic kit for longer-lasting results.
Pro tip: Get rid of any harsh chemicals in your home so you can avoid dryness on your hands
Can you Put Regular Nail Polish over Builder Gel?
Yes, you can use regular nail polish over builder gel. However, this will not last as long since it is not formulated for that type of product.
The best way to get the most out of your manicure would be to apply two coats of regular nail polish and then seal it with a clear topcoat.
You could also put on one layer of builder gel and then paint your nails like normal.
The debate has been going on for years.
Can you put regular nail polish over builder gel? Some people say yes, others say no! Well, we’re here to help break the tie and give you a definitive answer.
If you use nail polish over builder gel, then you need to use a quick-dry topcoat. This will seal in your manicure and keep it from chipping as easily as if you were just wearing regular nail polish alone.
What is a builder gel, though?
Builder gel is a type of acrylic that goes on like polish and dries to form a hard layer. It’s applied with an LED light (so it doesn’t need UV) and then filed down to create a smooth surface for painting on.
Builder gels are usually made of 100% pure monomeric liquid without any fillers, so you know you are getting quality results every time! Builder Gel comes in 12 colours and is available at most local beauty supply stores.
Can I Use Alcohol to Thin Gel Polish?
Have you ever wondered if it’s possible to use alcohol to thin out your gel polish? Many people assume that because alcohol is used for cleaning purposes, people should not use it on the nails.
However, this isn’t necessarily true. Alcohol can help thin out your gel nail polish so that it goes on smoother and lasts longer! You may be wondering how exactly you go about adding alcohol to your manicure routine.
A little bit of acetone or pure acetate will not cause any damage to your nails but adding too much can affect how well your polish stays on.
How to use alcohol to thin gel polish? Follow these six steps below:
1. Add a few drops of alcohol to your gel polish
2. Mix the alcohol and polish with a stir stick
3. Apply the mixture to nails as you would regular nail polish
4. Wait for it to dry before applying another coat, or use it as is if you want an opaque finish
5. Store the extra mixture in an airtight container so it doesn’t evaporate too quickly over time
6. Clean up any spills immediately with acetone-soaked cotton balls or paper towels
Conclusion- How to Fix Lumpy Gel Nails?
Gel nails are a great way to have your nails look perfect all the time, but they come with their challenges too.
For example, if you want to fix lumpy gel nail polish applied at home, it will take patience and probably more effort than just starting over when things go wrong.
You need to soak an old cotton ball in acetone for 10 minutes before using it on each finger where there is bad gel skin underneath; this process might take about another hour or two depending on how many fingers were messed up!Â
Why You Shouldn’t Apply More Gel Polish
Gel polish may become wrinkled or lumpy as soon as you apply it because it may already be of a thick consistency. As a result, once you place your hands underneath the UV light to cure the gel, it will prevent the light emitted from being able to reach the lower layers.
As a result, the top layer of the gel will start to wrinkle or become lumpy. Donâ€™t think that applying another layer of gel will help to resolve this situation â€” it will not.
Even though it may look smooth, the issue is that each layer of gel polish youâ€™ve applied will not have had sufficient time to cure. In turn, this will lead to the polish prematurely peeling off.
You need to remove the gel polish youâ€™ve just applied straightaway. It will take a lot less time to remove the gel when it has only just cured. Of course, if you happen to be applying a coat of gel polish to an old layer, then youâ€™ll also need to remove this as well.
Be aware it will take a lot longer for you to removem especially if it has been on your nails for a few days.
How to Avoid Lumpy Gel Nails
As weâ€™ve already discussed, lumpy nails after youâ€™ve applied a gel polish is a result of incomplete curing.
It is often due to either the gel applied to your nails being too thick or not using a device that provides a good source of UV light. It can also be a result of you failing to place your nails under a UV light lamp properly.
So, if you notice that the gel polish has become thick, you should immediately get rid of it and buy a new bottle. Also, you may want to consider investing in a good quality UV lamp to ensure that it provides sufficient light to cure the gel.
Finally, make sure that you know exactly how to place your hands underneath the light to be certain that the gel is getting sufficient levels of UV light on it.
Another thing you should do is always only wear a gel polish on your nails for a period of two-to-three weeks at a time before taking it off and applying a new layer. Also, it is worth leaving it off for a few days, as this will help to reduce the risk of you causing any possible damage to the surface of the nails or the cuticles.
In fact, if you choose to leave gel polish on for too long, it can cause the nails to weaken and also risks harmful bacteria causing damage. As soon as you notice that the gel has begun to lift away from your nails it is time to take it off.
Do you have a Problem with Bumpy Nails?
You might think that the solution is to just use a thinner topcoat. But it’s only going to make your problem worse!
The best way to fix this issue is by using one of these easy fixes:
â€¢Apply more polish on top of the bumpy spot and cure for an additional 30 seconds under UV light.
â€¢Remove as much gel from the brush as possible before applying polish onto the nail bed.Â
This will help reduce bubbles in between coats and allow you time enough for each layer to dry properly without smudging another layer with wet nails.
Cure for 10-15 seconds after application per usual procedure (depending on the brand).
Gel nails can be a pain to keep looking neat and tidy. But don’t worry, we got you covered! We want to share our best tips for fixing your gel mani when it gets lumpy or wrinkled in the application process.
The good news is that if done correctly, these fixes should work without any problems at all once again, proving that patience does pay off!
We hope this blog post has provided some useful information and some interesting nail hacks. Which one of these tricks did you try?